Instruction manual

– 19 –
When the digit to be set is flashing, release the mode switch.
At this point, if the MODE switch is pressed for less than two
seconds, each time it is pressed the digit value will change se-
quentially from 1 through 0 and return to 1. However, if the inch
unit is selected in the preset function, the final digit is limited to a
value of 0 or 5. When the setting of the final digit is completed,
“P” only flashes in the display. When it is necessary to perform
the setting again, press the MODE switch one more time for less
than two seconds.
The flashing position will once again return to “+” or “–”.
If the setting value is OK, press the MODE switch for two sec-
onds or longer and the “P” will stop flashing, the unit will be dis-
played, and return will be made to the preset function.
Note: When the RQ-2110 set limit data (upper lower limit value)
is being set, this preset value setting procedure is more
important and useful. Thus, even during a setting proce-
dure (i.e. when the display is flashing), the data value can
be transmitted, so that the limit set switch on the RQ-2110
can be pressed to set the limits ON.