Instruction manual

– 18 –

lease it to set the offset value at the instant the switch is re-

leased. The preset value setting procedure is noted below (Pre-

set Value Setting Procedure).

If “E” appears during measurement, perform a reset by switch-

ing the power off. By pressing the mode switch (for less than two

seconds) it is possible to switch through the sequence NORMAL

→ MAX → MIN → R, after which return is made to the normal

mode.

The MAX, MIN, R mode initial value is the displayed value at the

instant the MAX mode is reached by the normal mode. Once the

initial value has been set, it is held until the RESET switch is

pressed (for less than two seconds) and released. If it is neces-

sary to change the initial value, perform a reset. When doing this

the previous initial value will be cancelled and the displayed value

at the moment the MAX mode is selected from the normal mode

will be set as the new initial value. When the reset is performed,

the data output is “no data” when the RESET button is pressed

and the display is blank, and it changes to “0” when the RESET

is released and the display changes to “0”.

In the MAX, MIN, R mode if the RESET button is pressed (for

less than two seconds) and released, the initial value will be can-

celled and for the MAX or MIN mode the display will change to

the setting value. In the R mode, the display will be reset to “0”.

To return from the preset function to the normal measurement

function, press the RESET switch for longer than two seconds.

If the mode switch is pressed for longer than two seconds in the

preset function, “P” and “+” or “–” will flash on the display, indicat-

ing that the preset value setting procedure has been entered.

When this procedure is followed, the measurement units will dis-

appear from the display.

Set the units in the preset function.

The maximum setting value is 6.99995 for inch units and 69.999

for mm units. It is not possible to set values above these limits.

The RESET switch is operative in returning to the preset func-

tion. Press the Mode switch for less than two seconds, and the

“+” or “–” should flash alternately. When the desired setting po-

larity appears, press the MODE switch for longer than two sec-

onds. When this is done, the polarity selected will be set. At the

same time, the flashing point will move sequentially to the right.