Instruction manual

– 14 –
mum and minimum values).
The MAX, MIN and R modes are selected sequentially by
pressing the mode switch.
E: This error display indicates that the spindle has been
moved at a speed greater than the allowed limit, a condi-
tion causing possible measurement value error.
Because the spindle response speed is up to 500 mm s, a
counting error rarely ever occurs.
Should “E” appear in the display, however, indicating a
counting error, set the power switch to OFF to cancel “E”,
switch power ON and begin measurement once again.
B (B):This indicates that the battery voltage has fallen below a
set limit. When “B” appears in the display, it is time to re-
charge the battery.
If measurements are continued after “B” appears in the
display, to prevent complete battery discharge, “B” will
appear after a few seconds, approximately two seconds
after which the power will be switched off automatically.
5. DISPLAY DESCRIPTION
In addition to the measured value, the display indicates the fol-
lowing types of messages.
in: This annunciator indicates that inches have been selected
as the measurement unit.
mm: This annunciator indicates that millimeters have been se-
lected as the measurement unit. These annunciators cor-
respond to the setting of the inch/mm switch.
MAX: This indicates the maximum value display.
The displayed value does not change unless a measured
value greater than the displayed value is entered.
MIN: This indicates the minimum value display.
The displayed value does not change unless a measured
value less than the displayed value is entered.
R: This indicates the range (i.e., difference between maxi-