Instruction manual

– 10 –

and recording of outputs as well. Using the optional BH-100 In-

terface Unit, any computer which is equipped with RS-232C in-

terface can be used (with user application software) to perform

such functions as editing and calculation on measured values.

j Finger Lifter

k Contact Tip

l Mounting Lug

This lug is used to mount the gauge to a mounting fixture.

m Stem

This stem is grasped and held to mount the gauge to a gauge

stand.

n Spindle

1. Reset switch

If the normal function is set, and the RESET switch is pressed

for more than two seconds and released, the display will indicate

“AB”, indicating that the absolute zero function has been selected.

If the RESET switch is pressed once again and released, return

is made to the normal function.

If the switch is pressed further, the absolute zero and normal

functions will be selected alternately.

In the absolute zero function, the RESET switch cannot be used

to set the display value to zero.

When this function is selected, the RESET switch has two func-

tions.

(1) If the RESET switch is pressed for less than two seconds

and released, the displayed value in the NORMAL, MAX,