Instruction manual

– 8 –
then the (R) range (maximum to minimum) display mode, and
finally back to the normal measurement mode.
(1) In the normal measurement mode, the measured value is
continuously displayed.
(2) If the mode switch is pressed one (within two seconds), “MAX”
appears in the display, indicating that the maximum value
display mode has been reached.
In this mode, read-in measured values are continuously com-
pared and the maximum value measured is displayed.
(3) If the mode switch is pressed a second time, (within two sec-
onds), “MIN” appears in the display, indicating that the mini-
mum value has been reached.
In this mode, measured values are continuously compared
and the minimum value measured is displayed.
(4) If the mode switch is pressed a third time (within two sec-
onds), “R” appears in the display, indicating that the range
value display mode has been reached.
In this mode, the maximum and minimum values are inter-
nally registered in accordance with the up/down movement
of the spindle, with the range value (maximum-minimum
value) displayed continuously.
(5) If the mode switch is pressed once more (within two sec-
onds), “R” is extinguished from the display and return is made
to the normal measurement mode.
The initial value for the MAX, MIN and R display mode is the
value displayed when a switch is made to the MAX mode
from the normal mode. Once set, the initial value is held until
the reset switch is pressed (within two seconds) and then
released. If it is necessary to set initial value once again,
perform a reset. The previous initial value will then be can-
celled and the displayed value when a switch is made from
the normal mode to the MAX mode will be set as the initial
value.
(When a reset is performed, the data output is “no data” when
the reset switch is pressed and the display is blank, and is
“0” when the reset switch is released and the display changes
to “0”.)