Installation manual

Remote Controlled VCP Functions
5. REPLY BUTTON
Pressing this button will rewind tape and immediately begin playback when the tape is fully
rewound.
6. “REW” REWIND BUTTON
If this button is pushed while the tape is stopped, the tape will rewind. If this button is pushed while
the tape is playing, the VCP will go into rewind search mode. For more information, see page 10.
7. PLAY BUTTON
Press this button to activate play mode while a tape is loaded into the VCP. This button may also
be used to disengage search and pause modes. For more information, see page 10.
8. “F.FWD.” FAST FORWARD BUTTON
If this button is pushed while the tape is stopped, tape will fast forward. If this button is pushed
while the tape is playing, the VCP will go into fast forward search mode. For more information on
the search feature of the VCP, see page 10.
9. STOP BUTTON
Press this button to stop the tape.
Turning the VOH560 On or Off
1. Slide the screen release lock forward to unlock the LCD screen and it will drop down slightly.
Pivot the screen downward until a comfortable viewing angle is reached. The internal friction de
tent will hold the screen in position while the system is in use.
2. Pressing the power button on the pod or the remote will turn the system on or off alternately. When
in use the internal backlighting will illuminate the controls.
3. After the unit has been turned on and is displaying a picture, adjust the viewing angle, by pivoting
the screen to optimize the picture quality.
4. Remember to turn the unit off and pivot the LCD to the locked position when not in use.
Operation
Overhead Dome Lights
The lights integrated into the VOH560 are controlled by a three position slide switch. Sliding the switch
to the on position will turn the lights on. The off position will prevent the lights from turning on and off
with the vehicle’s interior lighting. Do not leave the vehicle unattended with the dome light switch in the
on position, as this could result in a discharged battery.
Dome
Light
Switch
-12-