- OWNER'S and INSTALL

COUNTERTOP/DESKTO P INSTALLATION

NOTE: Use caution to avoid damaging the LCD screen and the main unit when converting this unit

from an under-counter unit to a countertop unit. Leave the protective plastic on the screen until this

procedure is completed.

1) Place the unit (with the screen facing up) on a soft padded surface.

2) Pivot the screen so that it is perpendicular to the front of the unit and then turn it sideways.

3) Remove the hinge guide cove rs (#1) using a flat blade scre wdriver inserted into the removal

slots. Unscrew the mounting screws (#2). Remove the connector from the unit (#3), be

careful not to damage the screen (#5) or wires.

4) Turn the unit over and remove the blank cover (#4)

5) Connect the plug of the LCD monitor into the connector (# 3). NOTE: Align the “L” and “R”

stamped on the screen-mounting bracket with the “L” and “R” molded into the connector

housing.

6) Replace the screws and slide the hinge guide covers onto the unit, be careful to n ot damage

the wires. NOTE: Do not over-tighten.

7) Insert the rubber pieces (#6) (Foot, Mounting Cap - please refer to the illustration above) into

the unit. Install the blank cover on the unused port.