User guide

9
ENGLISH
USER GUIDE
8
3. Rotate the tube into the correct
position for use with the
earpiece.
Putting the tube back on
When you’ve nished cleaning the tube and dome, follow
these steps to put the tube back on the earpiece.
Tube
connector
1. Find the part of the tube that
connects to the earpiece (shown
here).
2. Place the hole on the bottom of
tube connector over the post on
the top of the earpiece (shown
here). Turn the tube sideways
on the top of the earpiece and
push straight down to attach
the tube to the earpiece.
If there’s wax in the tube: Use a section of
monolament shing line (medium to heavy-gauge) to
clean inside the tube. You can also use the tube-cleaning
rod from the RCA Symphonix cleaning kit, available
from the accessories brochure in this package or on
RCASymphonix.com.
Post
Cleaning the microphone and sound inlet
The microphone and sound inlet on your earpiece are
under the tube connector. To clean these parts, you must
rst remove the tube from the earpiece (see Cleaning the
tube and dome on the previous page).
Microphone
Once you’ve removed the tube
from the earpiece, you can use
a small brush to gently remove
any particles that may be on the
earpiece’s microphone or sound
inlet (shown here). DO NOT use
any liquids or solvents on the
earpiece.
Sound
inlet
Installing a New Tube
We recommend you replace your tube and dome every
3–4 months to keep the RPSA05 in top working order. You
can also replace the wide tube and dome that comes with
the RPSA05 with a thin tube and different-sized dome. A
variety of tubes and domes for the RPSA05 is available in
the Accessories brochure or through RCASymphonix.com
To replace the wide tube and dome
1. Find the part of the old tube
that is attached to the earpiece.
Gently rotate this section of the
tube so that the sound inlet is
exposed (as shown here).
Sound
inlet
2. Pull the tube straight off the
earpiece.
IMPORTANT: DO NOT pull the tube off at an angle. Doing so could harm
the tube connector or the components in your earpiece and void your
warranty.
Replacing the tube and dome
If you need to replace the tube and dome, use the
accessory brochure included in this package or visit
RCASymphonix.com. There are several kinds of tubes and
domes available—the one that comes with the RPSA05
is the wide tube and dome. See the Installing a New Tube
section for more information.
Putting the battery back in
When you’ve nished cleaning the tube and dome, follow
these steps to put the battery back into the earpiece.
1. Open the battery door on the back of the earpiece.
2. Place the battery into the battery door.
3. Close the battery door completely.