INSTALLATION MANUAL SP-6CD 6 - DISC CD CHANGER SYSTEM MODEL SP-6CD
PACKING LIST MAIN UNIT Changer INSTALLATION PARTS Bracket (L) Bracket (R) Self-Tapping Screw (M5 x 12) 1 pc. 1 pc. 4 pcs. Hexagonal Bolt with Washer M5 x 8 5 Meter DIN cable (8 pin) Seals 4 pcs. 1 pc. 1 pc. OTHER ACCESSORY 1 CD Magazine Index seal sheet Installation Manual Owner's guide 1 pc. 1 pc. 1 pc. 1 pc.
BEFORE INSTALLING THE UNIT Transport lock screws The mechanism in the CD changer is "locked" into place during shipment by the transport screws. Be sure to remove the screws prior to installation. Caution After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
SETTING THE ANTI-VIBRATION SPRINGS This unit can be installed horizontally (suspended), vertically, and at a 45° angle. Once the installation position has been decided, it's necessary to set the position of the built-in anti-vibration springs inside the unit. Please do this before performing the procedure. Vibration may cause the disc to skip if the unit is used before properly setting the anti-vibration springs.
PROCEDURE FOR VERTICAL INSTALLATION 1 Confirm that the built-in anti-vibration springs on both the left and right sides are set to the vertical installation position "V". Attach bracket (L) and bracket (R) using the hexagonal bolts (M5 x 8). 2 Determine the mounting location and drill four mounting holes. Never mount the unit near the fuel tank. Drill holes 4mm in diameter. 3 Secure the unit in place, using four self-tapping screws (M5 x 12).
PROCEDURE FOR MOUNTING UNDER REAR DECK 1 Confirm that the built-in anti-vibration springs on both the left and right sides are set to the horizontal installation position "H". Attach bracket (L) and bracket (R) using the hexagonal bolts (M5 x 8). 2 Determine the mounting location and drill four mounting holes. 4 mm 5 3 Attach the CD changer using four self-tapping screws (M5 x 12).
VEHICLE WIRING Mating 8-pin DIN socket on rear of compatible radio chassis (see Note 1 below). Car Stereo with CD Changer Controls DIN ca ble (8pin ) CD changer NOTE: 1. Check with your Audiovox car audio dealer to be sure your stereo is directly compatible with this CD changer. 2. Wiring instructions for use with FM Modulator/Commander Systems are included with the CDC-MC1, CDC-MCR2, P-MC3 and P-MCR4 accessories.
