User manual

Skybox Installation & User Manual
18
6 Installing the Antenna Cable
Installing the
Antenna Cable
This section will explain the proper method
for connecting the cable to the antenna, as
well as routing the coaxial cable from the
antenna to the Audiovox® indoor unit (IDU)
location.
6.1 Routing the Cable
The RF cable is routed from the antenna to
the IDU inside the vehicle. Decide where
to locate the IDU and satellite receiver, and
make sure that both units are placed in a dry
and protected area. Typically, they are placed
under a seat for protection. The IDU and
satellite receiver should be placed away from
any heat source and in an area with proper
ventilation. Ensure that there is at least 2” of
space around both units for ventilation and
connection of cables.
Two basic techniques for bringing the
antenna cable into the vehicle are through an
existing point of entry (POE) or by drilling
the POE.
6.2 Technique 1
The rst option is to route the cable into the
vehicle through an existing POE, such as
behind the rear hatch, between two body
panels or through a grommet.
NOTE
Only a trained automotive
technician should perform
this installation. Audiovox
®
is not respon-
sible for damage caused to vehicles by the
improper drilling or installation of antenna
cable through the roof or body of the vehicle.
NOTE
Due to the extensive variety
of vehicles on the market, it is
6.2.1 Routing Cables Through the
Rear Hatch
1. Connect one end of the TNC connector to
the back of the antenna at the rear of the
vehicle (Figure 6-1). Do not overtighten
this connection . The connection at the
antenna should be weatherized or protected
from outside elements through the use of
weather tape or other appropriate means.
impossible to cover all of the possible and
appropriate wiring specications for every
vehicle. Should you decide to run the cable
between body panels, take every precaution
to avoid areas prone to water inltration, and
to prevent damage to the vehicle’s body. If
the space between the vehicle’s panels is too
small, look for an alternate routing option.
Figure 6-1 Connector input from IDU.