Programming instructions

TROUBLESHOOTING - Horn / Chirps:
My system does not chirp when Arming and Disarming.
I cannot turn my chirps on ( or off ).
The alarm will set, but will not sound when opening a door.
Open the driver's door, then press the LOCK button to arm
the system. Did the horn chirp 3 times ?
SYMPTOMS
YES
NO
Does the SECURIKEY+ system make the horn
sound under any conditions, ( IE: full trigger, pre-
warn, or remote panic ?
YES
*Repair BROWN door
trigger wire from
alarm, or the defective
door pin switch, then
start over.
*Inspect and repair
GREEN with RED
STRIPE horn wire
from alarm harness.
YES
Defective module.
Replace module.
NO
QUESTION
Does the system operate properly now ?
*Turn the chirps ON according to the
procedure on page 9.
YES
Diagnosis
Completed.
NO
The procedure to turn
chirps on will not
work.
HELPFUL HINTS :
1) The arm and disarm chirps are turned on and off by using the L.E.D. / Valet switch in combination
with the ignition switch. The SECURIKEY+ system does not use dip switches to turn the chirps on
and off.
2) When the chirps are turned off, the 3 chirp ( armed with a door open - "defective zone" ) and 4 chirp
( disarm after alarm trigger - "intrusion alert" ) signals will always remain on. There is no way to defeat
the 3 and 4 chirp signals.
BEGIN TROUBLESHOOTING
QUESTION
Turn the ignition key to ON, then push the L.E.D.
/ Valet switch to the ON ( IN ) position. Does the
dash L.E.D. turn On ?
YES
*Repeat procedure to
turn chirps on, but
this time quicker. You
have only 5 seconds
to complete this.
*Repair connection
on YELLOW ignition
wire on the alarm
harness.
NO
QUESTION
Does the SECURIKEY+ system make the horn
sound under any conditions, ( IE: full trigger, pre-
warn, or remote panic ) now ?
Start again from the
beginning.
NO
Page 11