Installation manual

Installing the Power Harness

Tap/Run Connection

1. Wire the Power Harness to the vehicle’s reverse lamp.

a) Locate the reverse lamp in the tail light assembly. Using the tap

connector supplied, perform the following steps:

i. Place the un-stripped positive lead wire on the run channel.

ii. Insert the un-stripped red power wire completely.

iii. Make the connection between the wires by crimping down the

metal connector with a pair of pliers, making sure the metal is

flush with the plastic insulator.

iv. Close the top hinged cover until latched.

b) Attach the black to the vehicle body, either directly with supplied

hardware or by attaching to a wire directly attached to the vehicle

body. If attaching to another wire:

i. Place the un-stripped ground lead wire on the

run channel.

ii. Insert the un-stripped black ground wire completely.

iii. Make the connection between the wires by crimping down

the metal connector with a pair of pliers, making sure the

metal is flush with the plastic insulator.

iv. Close the top hinged cover until latched.

2. Route the power harness wires with the sensor wires to the control box.