Installation manual

Diagnostics / Trouble Shooting
Problem Solution
No sound when reverse gear is
engaged.
1. Check if ignition/reverse light on
2. Check power cable connection
3. Check switch on speaker
1 Beep System is functioning correctly
2 Beeps 1 sensor is disconnected/damaged
3 Beeps 2-3 Sensors are disconnected/damaged
4 Beeps No sensors are connected
System beeping without
obstacle behind vehicle
1. Ensure sensor is mounted upright.
2. Remove anything mounted on the
vehicle that may be in the detection
area.
3. Ensure correct hole size has been
drilled in bumper.
4. Verify sensor is installed at the correct
height.
5. Verify sensor is in the correct position.
6. Check all connections.
7. Ensure module is not mounted near
electrical components with high
current.
8. Verify supporter was used if required
(angled/metal bumpers).
11