INSTALLATION/ OWNERS MANUAL 6.0 Inch TWO-WAY SPEAKERS Release 6-10-03.
SPECIFICATIONS SPEAK ER Nomi nal D i ameter 6" D escri pti on 2-Way Impedance 4 Ohms F req. Response (Hz) 100-18000 S ensi ti vi ty (dB ) 90 P ower Handli ng 120 Watts Magnet Wei ght 7 oz.
PRE-INSTALLATION TIPS Before beginning your installation, read the following tips on proper placement of speakers and how to obtain the best sound from the speakers you have selected. or fire panels make poor mounting surfaces and tend to vibrate when used. This is far more critical when installing large power producing woofers. Mount your speakers securely! If the speaker has four mounting holes, use all of them. No. 1: Always try to have the speakers aimed at the listener.
INSTALLATION INSTRUCTIONS CAUTION: Do not mount the speakers in the following locations: - Where the door window glass comes in contact with the speaker. - Where the window crank handles or gear assemblies come in contact with the speaker when rotated. - Where the speakers come in contact with the trunk springs, shock towers, or trunk lid. - Where the speakers come in contact with gas tanks or fuel lines. - Where the speakers come in contact with the rear window glass, car wall, etc.
If necessary, remove the door opening handle any accessory. Unless screws are holding the door panel to the door frame, which is very rare, you will find that most door panels are secured by spring clips. 3. Using a broad flat tool between door and door panel, unfasten spring clips. If a few clips are bent when removing them, a pair of pliers will easily re-form them. Once all clips are unfastened, lift off door panel. 6. Door latch 7. Screws 8.
1. Using the template provided (we’ll assume you’ve already made all the necessary checks and you’ve not going to cut through the door release mechanism), mark the speaker opening on the door panel. Now carefully cut the opening and drill the required holes. NOTE: Whether you’re using an existing hole, or have just cut or modified an existing opening as described above, you are now ready for speaker installation. 2. Place the speaker into the opening and check for proper fit.
Enlarging or Cutting a New Hole Piercing Speaker Mounting Holes 1. Opening 2. Speaker 3. Pierce the speaker mounting holes 1. 2. 3. 4. 5. Enlarge or cut new hole per template Tape Template Metal cutting saw File hole smooth after cutting Cutting Door Padding and Piercing Speaker Mounting Holes After routing the speaker wires, perform the final installation as follows: 1. Replace door panel, window crank, etc. Press against door panel to locate speaker hole.
Routing Speaker Wires 3. Place speaker into door and secure using screws (and clips, if necessary) provided with speaker. Route the speaker wires as follows: 1. Route speaker wires from stereo into door. If possible, use existing wires. If door is not equipped with grommets, drill a 1/4” hole in door edge and door frame. 4. Test the speaker. Then install grille (grille snaps over outer ring of speaker frame). Repeat for remaining door. 2. Connect wires to speaker per stereo wiring instructions.
Speaker Mounting Details The following illustrations define the requirements for mounting the speaker on the near and far sides of the mounting surface or independent mounting board.
® 90 DAY LIMITED WARRANTY Applies to Speakers. AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.
