Installation Manual

128-9324
12 of 12
PRO9233E
Green/Black Arm2
Red Disarm 1
Green Arm 1
Red/Black Disarm 2
Blue Trunk Shunt
Pushbutton
LED Assembly
Red
Green
Red = (-) Lock (+) Unlock
Green = (+) Lock (-) Unlock
Red (+)
Black (Ground)
Green (Full Trigger)
Blue (Pre Detect)
To Shock Sensor
To Optional One
Or Two Way
Telematic Module
To FlashLogic Module
When Being Used
Green/Black
Auxiliary Output (-) 300mA
Can Be Used For Remote Start
Trunk Release
Window Roll Up
Dark Green
(-) Tigger Input Connect
To Hood & or Trunk Pin
Switch
LT. Green
(-) Trigger Input Zone 1
Connect To Optional
Negative Triggering Device
Brown
(-) Negative Door Trigger Input
Connect To Existing Door Pin
Circuit In Vehicle
Orange (- Starter Inhibit Output)
30
87a
8586
87
Black
Black/White
Existing Low Current
Start Solenoid Wire
From Ignition Switch
Start Terminal
To Starter Motor
X
Cut
To + 12 Volt
Ignition / Start
Black
Chassis Ground
Low Current (-) Output To
Operate Vehicle’s Horn Relay
Left Parking Lamp Right Parking Lamp
-
-
Red/White
5A
15A
(+) 12 Volt Supply To
Parking Light Relay
& Control Module
White
Red
White/Black
To (+) Side Of
Optional Siren
(+) Positive Door Trigger Input
Connect To Existing Door Pin
Circuit In Vehicle
Purple
Ignition Input
Connect To + 12 Volts
Ignition / Crank
Yellow
Green/White
86
85
To Fused + 12 Volt Source
87a87
30
To Entry
Illumination
Wire Of Vehicle
Connect to (+) If Vehicle’s
Interion Light Switched (+)
Connect to (-) If Vehicle’s
Interior Light Switched (-)
PRO9233E
Black/White
Black/White
©2014 Voxx Electronics Corp., 150 Marcus Blvd. Hauppauge, N.Y. 11788 128-9324
Page 12