Owner's Manual
Table Of Contents
- Installation Guide
- Table of Contents
- Supplied Accessories
- Installation
- Tools Required / Preparation
- Installing the Snap-On Shroud
- Installing the Snap-On Screen Cover
- Installing the Trim Ring
- General Vehicle Installation Approach
- Vehicle Preparation
- Connecting the Dome Lights
- Installing the Mounting Bracket
- Wiring Diagram
- Mounting the Unit
- Removing the Screen Back Cover
- Removing the Trim Ring and Shroud
- Installing the Optional Thick Trim Ring
- Installing the Optional SmartStream Module (WM1)
- Troubleshooting
- Owners Manual
- Warranty
15
1. Push in the Screen Release button to unlock the LCD screen. The screen will drop down
slightly.
2. Pivot the screen downward until a comfortable viewing angle is reached. The hinge friction
will hold the screen in position while the system is in use.
3. Press the power button on the unit or the remote control to turn the system on and off.
When in use, the internal backlighting will illuminate the controls.
After the unit has been turned on and is displaying a picture, adjust the viewing angle by
pivoting the screen to optimize the picture quality.
5. Remember to turn the unit off and pivot the LCD screen to the locked position when not
in use.
Power ON/OFF
Button
Screen Release
Turning the unit on or o