Owner's Manual
Table Of Contents
- Installation Guide
- Table of Contents
- Supplied Accessories
- Installation
- Tools Required / Preparation
- Installing the Snap-On Shroud
- Installing the Snap-On Screen Cover
- Installing the Trim Ring
- General Vehicle Installation Approach
- Vehicle Preparation
- Connecting the Dome Lights
- Installing the Mounting Bracket
- Wiring Diagram
- Mounting the Unit
- Removing the Screen Back Cover
- Removing the Trim Ring and Shroud
- Installing the Optional Thick Trim Ring
- Installing the Optional SmartStream Module (WM1)
- Troubleshooting
- Owners Manual
- Warranty
24
Troubleshooting
SYMPTOM:
No power at video monitor
Power but no video or sound
Disc will not play or wrong region is
displayed
IR Wireless Headphones do not work
REMEDY:
t Verify +12 VDC on the Red wire at 6 Pin Power/
Dome Light Harness behind the video monitor.
Verify a ground connection with a continuity test
from a known good ground to the black wire.
t Verify that the Source is on and playing back
compatible media content.
t Check to ensure the disc was put in with the
correct side for playback (Label side up/shiny side
down). NOTE: The DVD system only plays digital
video discs, audio CDs and MP3s.
t Both the unit and the disc are coded by region. If
the regional codes don’t match, the disc can’t be
played. This DVD player is set to Region 1.
t Check if batteries are installed correctly.
t Make sure that the headphone batteries are fresh.
t Check if Power Button lights up when pressed.
If Power Button does not light up when pressed,
change batteries.
t If using Dual Channel Wireless Headphones, make
sure the correct channel is selected.
t Make sure the IRT power is ON. Press the IRT ON/
OFF button on the remote control and IRT ON or
IRT OFF is displayed.