Owner's Manual

21
Appendix A - Removing the Trim Ring and Shroud
Removing the Trim Ring
1. Remove the Trim Ring screws ((8) M3 x 5mm screws).
NOTE: Do not Discard Screws! These screws are used to attach the new Trim Ring.
2. Remove the Trim Ring and discard.
（8）
（7）
（6）
（5）
（1）
（2）
（3）
（4）
TRIM RING SCREW
(8) M3 X 5mm Screws
Removing the Shroud
1. Using the supplied pry tool, remove the slide knob from the dome light switch
located on the side of the DVD player.
NOTE:
Do not Discard knob! The knob is reused.
2. Open the screen and insert the supplied pry tool between the Housing and Shroud
and disengage the tape on the center section of the shroud.
3. Press the pry tool to disengage the attaching Shroud clips.
4. Continue disengaging the attaching areas around the unit removing the Shroud
and discard.