Owner's Manual
Table Of Contents
- Installation Guide
- Table of Contents
- Supplied Accessories
- Installation
- Tools Required / Preparation
- Installing the Snap-On Shroud
- Installing the Snap-On Screen Cover
- Installing the Trim Ring
- General Vehicle Installation Approach
- Vehicle Preparation
- Connecting the Dome Lights
- Installing the Mounting Bracket
- Wiring Diagram
- Mounting the Unit
- Removing the Screen Back Cover
- Removing the Trim Ring and Shroud
- Installing the Optional Thick Trim Ring
- Installing the Optional SmartStream Module (WM1)
- Troubleshooting
- Owners Manual
- Warranty
20
Appendix A - Removing the Screen Back Cover
This section is intended for situations where the color of the Shroud, Screen Cover and Trim
Ring need to be changed after the unit is setup for installation.
NOTE: Work on a soft surface to avoid damaging the plastic.
Removing the Screen Back Cover
1. Starting from the back of the unit, carefully insert the supplied pry tool between the
Housing and Screen Back Cover
2. Press the pry tool to release the Screen Back Cover.
3. While lifting the Screen Back Cover, slide the pry tool around to the attaching areas
and press the pry tool to release the Screen Back Cover.
4. Remove the Screen Back Cover and discard.