Owner's Manual
Table Of Contents
- Installation Guide
- Table of Contents
- Supplied Accessories
- Installation
- Tools Required / Preparation
- Installing the Snap-On Shroud
- Installing the Snap-On Screen Cover
- Installing the Trim Ring
- General Vehicle Installation Approach
- Vehicle Preparation
- Connecting the Dome Lights
- Installing the Mounting Bracket
- Wiring Diagram
- Mounting the Unit
- Removing the Screen Back Cover
- Removing the Trim Ring and Shroud
- Installing the Optional Thick Trim Ring
- Installing the Optional SmartStream Module (WM1)
- Troubleshooting
- Owners Manual
- Warranty
17
Installing the Unit Video System-Wiring Diagram
1. Connect the 6 pin harness to the unit and make the connections to the vehicle.
2. Connect the red and black power wires of the Power Harness to vehicle’s electrical
system by connecting into an accessory hot line and a good ground.Soldering
all power connection is the suggested technique that should be used to ensure a
problem free connection.
3. If connecting to an external source, connect the 5 Pin AV Input Harness (112-4259
Blue Connector) to provide AV signal input to the system.
4. If connecting to an external source, connect the if used 5 Pin AV Output Harness
(112-4260 White Connector) to provide AV signal output from the system.
5. Verify all system functions before nal mounting of the nished assembly.
Input Source Options
t Internal User Accessible:
DVD/USB/HD/AUX AV Inputs
t External Hidden:
AV Input via supplied harness 112-4259
AV Output via supplied harness 112-4260
Wireless Content Streaming via optional SmartStream module (WM1)
Remote HD/USB connection via optional cable (HDH12)
NOTE: The antenna has been designed for optimal performance.
When installing the unit, position the antenna for best reception.