Owner's Manual

ManualsBrandsAudiovox ManualsSafety and ConvenienceAudiovox LCDM40A

Model: LCDM40A

4.0” LCD Rear Vision Mirror Monitor

User Manual

Features

Mirror with built in 4.0” LCD Superbright Monitor

Low Profile, Slim Design

High Resolution LED Backlit LCD TFT

Built in Speaker

Two video inputs

Fully Adjustable

Auto screen brightness adjustment

Summary of content (5 pages)

PAGE 1
Model: LCDM40A 4.0” LCD Rear Vision Mirror Monitor User Manual Features Mirror with built in 4.
PAGE 2
Warnings The product is intended to assist in safe driving and to allow the driver to have a broader rear view while the vehicle is in reverse. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle.
PAGE 3
Using the System The LCDM40A is installed in conjunction with an Advent reverse safety camera. The LCDM40A will automatically turn on when the vehicle is placed in Reverse. You can activate the monitor at any time by pressing the large front button on the front of the mirror housing. NOTE: Your camera must be on to see the image. If your camera was not wired for power all the time then pressing the button will not display an image. Holding down the large front button will turn the system off.
PAGE 4
Troubleshooting Symptom Solution No power to the monitor 7. Check that reverse power is attached to orange wire. 8. Check that accessory power is attached to red wire 9. Check that black wire is attached to vehicle body (ground) 10. Check fuse and if blown ONLY replace with a fuse of the same amperage. No image from backup camera when vehicle placed in reverse Check that camera is functioning correctly Check that orange wire is attached to reverse power.
PAGE 5
4