Model: LCDM40A 4.0” LCD Rear Vision Mirror Monitor Installation Manual Features Mirror with built in 4.
Table of Contents Warnings ...................................................................................... 3 Product Description ..................................................................... 4 Packing List ................................................................................. 4 Monitor Installation ..................................................................... 5 Monitor Wiring Diagram ............................................................. 8 Specifications ............
Warnings The product is intended to assist in safe driving and to allow the driver to have a broader rear view while the vehicle is in reverse. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle.
Product Description This advanced high resolution monitor will show a clear picture from a reversing camera or any other video source. The modern thin design and easy factory mirror replacement allows the installation of a high quality LCD monitor securely in the vehicle without obstructing the drivers view.
LCD Monitor Installation 1. Remove the factory rear view mirror. (Use caution, some mirrors require specific tools to remove, seek additional help if you do not know how to remove a mirror). 2. Check and determine if the factory metal mounting lug is compatible with the mounting arm on the LCDM40 or with the Toyota/Honda adaptor supplied (see Arm Adaptor subsection). a) If possible, attach the LCDM40 to the factory metal mounting lug and secure with the locking screw.
when equipped with a microphone the audio will be heard on the speaker built into the mirror housing. 7. Follow the installation and wiring instructions for the camera you are using. 8. Connect the LCDM40 Monitor to the harness. 9. Power up and adjust on screen settings. In order to see an image you must be in Reverse gear. NOTE: To adjust monitor settings press the MENU button on the bottom of the mirror to scroll through options. Use the + and – buttons to make adjustments as needed.
Wiring the Camera to the Vehicle’s Reverse Lamp 1. Locate the reverse lamp in the tail light assembly. 2. Using the tap connector supplied, perform the following steps: a) Place the un-stripped positive lead from the tail lamp in the run channel, which runs completely through the connector. b) Insert the un-stripped red power wire from the camera completely into the other channel in the connector.
Monitor Wiring Diagram Note: If used with an Advent camera – the power and signal will be provided through a single cable from the monitor.
Specifications 1. 2. 3. 4. 5. 6.
Troubleshooting Symptom No power to the monitor No image from backup camera when vehicle placed in reverse Image is mirrored or requires adjustment Sound can not be heard from Advent camera Solution 1. Check that reverse power is attached to orange wire. 2. Check that accessory power is attached to red wire 3. Check that black wire is attached to vehicle body (ground) 4. Check fuse and if blown ONLY replace with a fuse of the same rating. 1. Check that camera is functioning correctly 2.
