ASA Electronics TV/VCP Floor Console Model K-13 Without Harness and Antenna 12 Volt DC powered remote controlled 13” television AVT-1475 12 Volt DC powered remote controlled VHS Video Cassette Player AVP-7000 Installation Instructions Audiovox Specialized Applications, LLC. “The Mobile Electronics Company” 23319 Cooper Drive Elkhart IN 46514 1 (219) 264-3135 www.audiovox.com Page1 of 10 P/N 8007131 Rev.
This manual contains specific instructions on how to install this automotive TV/VCP floor console. Please read this manual thoroughly before installing the console into the vehicle. **WARNING** In order to maintain a safe mounting system, this console MUST be secured to the floor of the vehicle according to the instructions contained in this manual. Failure to do so may result in the console becoming a projectile in the event of an accident.
There are six (6) steps to install the K-13 TV/VCP floor console: Step # 1 Step # 2 Step # 3 Step # 4 Step # 5 Step # 6 Disassemble shroud Install brackets and straps Mount the console on the floor of the vehicle Install the VCP Install the TV Replace the console face and rear shroud STEP #1) Disassemble shroud. ⇒ Remove the 4 Phillips screws securing the face of the console. Page3 of 10 P/N 8007131 Rev.
Step #2) Install brackets and straps 1) Mount brackets, using only four screws. Do not use center hole. 2) Use soldering iron, if necessary, to melt holes in open strap and loop strap, as shown. Page4 of 10 P/N 8007131 Rev.
3) Pre-drill pilot holes on side of VCP shelf (A) and on bottom of TV shelf (B) using 1/8” drill bit. (A) (B) Page5 of 10 P/N 8007131 Rev.
4) Attach both straps, use TV and VCP to help locate strap if necessary. Page6 of 10 P/N 8007131 Rev.
Step 3) Install console to floor of vehicle. ⇒ BEFORE DRILLING ANY HOLES VERIFY THAT THE DRILL BIT WILL NOT ENTER INTO THE FRAME RAIL(S) OF THE VEHICLE, ELECTRICAL WIRES, FUEL LINES, BRAKE LINES, HOSES, EXHAUST SYSTEMS OR ANY OTHER ITEMS THAT WILL IMPAIR THE OPERATION OF THE VEHICLE. THE BOLTS OF THE FLOOR CONSOLE MUST SECURE TO THE FLOOR PANEL OF THE VEHICLE. CLIMB UNDER THE VEHICLE AND LOOK TO VERIFY THAT THE HOLES WILL BE IN THE PROPER LOCATIONS.
Step 4) Install the VCP into the console. ⇒ Remove the VCP from the box. ⇒ Connect the white RCA connector (customer supplied) from the console to the white audio output of the VCP ⇒ Connect the yellow RCA connector (customer supplied) from the console to the yellow audio output of the VCP ⇒ Connect the DC power connector (customer supplied) to the DC power jack of the VCP.
Step 5) Install the TV into the console. ⇒ Connect the yellow RCA patch cord (customer supplied) to the yellow RCA video input jack on the rear of the television ⇒ Connect the white RCA patch cord (customer supplied) to the white RCA audio input on the rear of the television ⇒ Connect the DC power connector (customer supplied) to the rear of the television ⇒ Connect the antenna “F” connector (customer supplied) to the rear of the television ⇒ Place the television on the shelf of the console.
Step 6) Replace the rear shroud and face of console. ⇒ Place the rear and face of the console over the body of the console. Gently tap into place. ⇒ Reinstall the four Phillips screws that held the face to the body. Page10 of 10 P/N 8007131 Rev.
