HR7011PKG Two Custom Vehicle Headrests with 7” LCD Monitors Touch Screen Control and Built-in DVD Player for Rear Entertainment AUX AUX Installation Guide 128-8939
IMPORTANT NOTICE Installation of headrest products require careful planning and preparation. Be extremely careful of seats that have airbags built into them. Keep wiring away from any air bag wiring (usually identified by yellow connectors and yellow wire jackets). Damage to air bag wiring can result in personal injury to vehicle occupants. If you have any questions regarding wire routing or installation in a vehicle, please contact Audiovox Technical Support at 1-800-225-6074.
MATERIAL TO USE IN THIS PACKAGE: 1) HR7011PKG System Monitor (P/N HR7011M) (2 pcs) Monitor with touch screen control and DVD Player M1/M2 Note: The HR7011M touch screen monitor has been designed to be interchangeable from one headrest to the other. The wireless FMM Interface Box automatically determines which headrest is M1 and which headrest is M2 and sets each headrest to its own function (IR transmitter channel and IR receiver remote control codes).
HR7011PKG SYSTEM OVERVIEW 1) The HR7011PKG SYSTEM is a versatile audio / video system with built-in DVD player HR7011PKG which includes two touch screen monitors, that can accept an Audio / Video input and independent AUX input. A separate audio output is provided for connecting an optional FM Modulator to the vehicle’s radio. 2) The M1 Monitor is comprised of a 7" Touch Screen TFT LCD monitor with built-in DVD player that allows the user to select from the DVD, USB, M2, AUX, AV, MEDIA and, GAME source.
9) Pivot the screen until a comfortable viewing angle reached. The internal lock limits the screen to a maximum adjustment of 19 degrees from closed position. The headrest itself can be tilted forward to help achieve a comfortable viewing position. PUSH UP Internal Lock Shaft Angle AUX Open Position USB JACK PULL UP WIRED HEADPHONE 10) Insert/Eject disc.
VEHICLE PREPARATION 1) Read the manuals and get familiar with the electrical requirements and connections. 2) Prepare the vehicle by removing any interior trim necessary to gain access to the vehicle's wiring as well as all areas where interconnecting wire harnesses will be located. The mounting method and the location will vary from vehicle to vehicle, so this manual will only focus on the installation of the Master and Satellite Monitors in the supplied configuration.
) Connect all the components together (electrically) and verify proper operation of all the system functions. a. The headrest DIN cables and the FMM Interface Box DIN cables are color coded. Connect each headrest cable to the correct color cable on the FMM Interface Box. b. Extend the wireless FM antenna to its full length and orientate for best reception. Do not place it on the FMM Interface Box or near metal. c. Connect the DC power jack.
ELECTRONICS INSTALLATION GUIDE Monitor Unit (Master Monitor) Install Monitor Unit to Headrest (Satellite Monitor) (Master Monitor / M1) 1 Monitor must be in closed position. Insert Eject Card at top slot to the end. 4 (Satellite Monitor / M2) 3 2 Hold the Eject Card then press monitor and pull it out. Press the release tab to release the monitor completely.
6 7 8 9 10 Move the locking tab to right position to fully insert the monitor into the headrest With Screw (x4) 11 9
HR7011PKG WIRING DIAGRAM M1 Monitor M2 Monitor Master Monitor Satellite Monitor 12 Pin AV Adapter Cable GREEN DC IN 2 PIN DC POWER CABLE AV Input AV Output INTERFACE BOX FM ANTENNA OPTIONAL Relay Box SIRSWB Relay Box for wireless FM MOD See antenna note below See the instructions supplied with the SIRSWB for installation.
This page intentionally left blank.
© 2011 Audiovox Electronics Corp.
