HR7008PKG Two Specific Vehicle Headrests With 7" LCD Monitors Touch Screen control and Built-In DVD Player for Rear Seat Entertainment Installation Guide 128-8311
IMPORTANT Installation of headrest products require careful planning and preparation. Be extremely careful of seats that have airbags built into them. Keep wiring away from any air bag wiring (usually identified by yellow connectors and yellow wire jackets). Damage to air bag wiring can result in personal injury to vehicle occupants. If you have any questions regarding wire routing or installation in a vehicle, please contact Audiovox Technical Support at 1-800-225-6074.
MATERIALS TO USE IN THIS PACKAGE: 1) HR7008PKG System Monitor M1 Monitor with touch screen control and DVD Player (1pc) M2 Monitor with touch screen control and DVD Player (1pc) M1 M2 Note : M1 Monitor include master monitor headrest cable (P/N 112-3942) & hardware screws Note : M2 Monitor include satellite monitor headrest cable (P/N 112-3943) & hardware screws 3) Wireless FMM Interface Box (P/N 136-4658) – (1pc) 2) Remote Control with Wireless Game Controller (P/N 136-4657) – (2pcs) POWER EJECT M1
HR7008PKG SYSTEM OVERVIEW 1) The HR7008PKG SYSTEM is a versatile audio / video system with built-in DVD player HR7008M1/M2 which includes two touch screen monitors, that can accept an Audio / Video input and independent AUX input. A separate audio output is provided for connecting an optional FM Modulator to the vehicle's radio.
9) Pivot the screen until a comfortable viewing angle reached. The internal lock limits the screen to a maximum adjustment of 19 degrees from closed position, the headrest itself can be tilted forward to help achieve a comfortable viewing position.
HR7008PKG Electronics Installation Guide Monitor Unit HR7008M1 (Master Monitor) Install Monitor Unit to Headress HR7008M2 (Satellite Monitor) HR7008 Monitor (Master Monitor / M1) 3 1 2 Insert Eject Card at top slot to the end. Hold the Eject Card then press monitor and pull it out.
6 8 9 10 With Screw (x4) 11 Move the locking tab to right position to fully insert the monitor into the headrest 12 Adjust match your vehicle seatback dimension 7
VEHICLE PREPARATION: 1) Read the manuals and get familiar with the electrical requirements and connections. 2) Prepare the vehicle by removing any interior trim necessary to gain access to the vehicle's wiring as well as all areas where interconnecting wire harnesses will be located. (Refer to the Installation Procedure).
7) Connect all the components together (electrically) and verify proper operation of all the system functions. A) The headrest DIN cables and the FMM inter-connect box DIN cables are color coded. Connect each headrest cable to the correct color cable on the FMM inter-connect box. In some vehicles it will be necessary to use the supplied DIN extension cables to reach from under one seat to the other seat. The DIN extension cables can be used for either the M1 or M2 monitors.
HR7008PKG WIRING DIAGRAM M2 Monitor M1 Monitor Satellite Monitor Master Monitor BLUE 2 PIN DC POWER CABLE DC IN AV Input AV Output INTERFACE BOX FM ANTENNA Optional DIN Extension Cables Antenna for wireless FM MOD See antenna note below 10 YELLOW GREEN RED
WWW © 2008 Audiovox Electronics Corp.
