Answering Machine User Manual

If you have difficulty operating your
phone. the suggestions below should
solve the problem. If you still have
difficulty after trying these
suggestions. call AUDIOVOX
COMMUNICATIONS at (800) 229-
1235.
YOU GET NOISE, sTATlc.16~ A:
WEAK SIGNAL WHEN ::VOUORE
," ..' "
AWAY FROM THE BASE'UNIT.;"~;
-.c
.You may be out of range. Either
move close to the base, or relocate
the base unit.
.The layout of your home may be
limiting the range. Try moving the
base unit to another position.
THE PHONE DOESN'T WORK AT
ALL
.Make sure the Power Cord is
pugged
.Make sure the telephone line
cord is plugg~d firmly into the
base unit and the telephone wall
jack.
.Make sure the batteries are
properly charged. If the 'LOW
BATTERY' message is shown, the
battery pack needs charging.
-+
-@-
THE HANDSET DOES NOT, RING
WHEN YOu RECEIVE A CALL.
..,
.Make sure you have'the handset
ringer activated. To set the ringer,
see .PROGRAMMING THE
RINGER..
.Make sure the telephone line
cord is plugged firmly into the
base unit and the telephone jack.
Make sure the power cord is
plugged in.
.You may be too far from the base
unit.
.You may have too mahy extension
phones on your telephone line to
allow all of them to ring. Try
unplugging some of the other
phones.
NO DIAL TONE.
First check all the suggestions
above.
It you still don't hear a dial tone,
disconnect the base unit from the
telephone jack and connect a
different phone. It there is no dial
tone on that phone either, the
problem is in your wiring or local
service. Call your local telephone
company.
YOU GET NOISE, STATIC, OR A
WEAK SIGNAL EVEN WHEN YOU'RE
NEAR THE BASE UNIT .
.Household appliances plugged
into the same circuit as the base
unit can sometimes cause
interference. Try moving the
appliance or the base unit to
another outlet.
YOU HEAR NOISEINTHEHANDSET ~
."
AND NONE OF THE:'KEYS OR
BUTTONS WORK. ,:,:",-:.j. ..i~
Make sure the power cord is plugged
in.
42
rF
-I
--:-
6124/98. 12:20 PM
OT94102p65
42
,
-@-