Installation manual

9
Route the camera wiring into the vehicle. The wire can be run through an
existing grommet, behind a tail lamp, under the trunk molding, or if
necessary, through a 5/8 inch hole drilled near the vehicle’s rear license
plate. When choosing a wiring path, make sure the cable will not be
damaged or pinched, as this may cause a short circuit that is not
covered by the warranty. If drilling a hole, perform the following steps:
a) Acquire a 5/8 inch drill bit, rust preventive, all of which can be
purchased at a hardware store.
b) Check behind the intended drilling location before drilling to
verify that no wires or mechanisms can interfere with or be
damaged during drilling.
c) Check for interference with license plate lights and the hatch
release switch and/or mechanism.
d) Drill a 5/8 inch hole at the selected location.
e) Coat the edge of the hole with rust preventative.
f) Route the camera cable through the grommet and then through
the hole.
g) Insert the grommet in the hole to keep water from entering the
vehicle.
h) Adjust camera angle so that in standard reversing views you can
see a small piece of the bumper and then tighten the mounting
screws.