Installation manual

19
Specifications
•Voltage: +12V (9 ~ 16V allow)
•Output image: CVBS, NTSC
•Video Signal: 1.0Vp-p, 75ohm driver capacity
•View angle
Horizontal: 190° (Panoramic view), 130° (Rear view)
Vertical: 150° (Panoramic view), 110° (Rear view)
•Image Sensor: CMOS, 1Mega Pixel
•Low lux: 0.5 lux
•S/N: 38dB or more
•Water proof: IP69
•Operating Temperature: -40℃ ~ + 85℃
•Storage Temperature: -40℃ ~ +105℃
Troubleshooting
Symptom
Solution
No video signal appears while
reversing the vehicle
Check the rear view camera lens
and clean if needed.
Check the rear view camera wiring
connection and RCA connection.
Check the fuse, if blown replace
ONLY with the correct size.
Video image is not sharp enough
Clean the camera lens.