Installation manual
11
e) Coat the edge of the hole with rust preventative.
f) Route the camera cable through the grommet and then through
the hole.
g) Insert the grommet in the hole to keep water from entering the
vehicle.
h) Remove the camera from the license plate bracket and attach it to
the surface mount bracket on the vehicle.
i) Adjust camera angle so that in standard reversing views you can
see a small piece of the bumper and then tighten the mounting
screws.
Obtaining Reverse Power
1) Locate the reverse lamp in the tail light assembly.
Using the tap connector supplied, perform the following steps:
Place the un-stripped positive lead from the tail lamp in the run channel,
which runs completely through the connector.
Insert the un-stripped red power wire from the camera completely into the
other channel in the connector.
Make the connection between the wires by crimping down the metal
connector with a pair of pliers, making sure the metal is flush with the
plastic insulator.
Close the top plastic hinged cover until latched.
Attach the black wire to the ground (negative).
Repeat the above steps for the red wire.