Operating instructions

Additional information
10
10
60
56
7
4
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the
factory default. Use the front panel controls to do this.
For instructions on resetting the network connection
settings, see Factory Reset
on page 42.
1
Switch the receiver into standby.
2
While holding down
BAND
, press and hold
STANDBY/ON
for about two seconds.
3
When you see RESET? appear in the display, press
AUTO SURROUND/STREAM DIRECT
.
OK? shows in the display.
4
Press
ALC/STANDARD SURR
to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Important
If the Control with HDMI function is set to ON, the HDMI
function’s Standby Through is set to anything other than
OFF, or the Network Standby is set to ON, you may not be
able to reset the unit. In this case, reset either by turning
OFF the Control with HDMI function, or by putting the unit
into standby mode by turning off the power of all the
connected devices, and resetting after the HDMI indicator
on the front panel turns off.
Cleaning the unit
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the surface is dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six times with water,
and wrung out well, and then wipe again with a dry cloth.
Do not use furniture wax or cleansers.
Never use thinners, benzine, insecticide sprays or other
chemicals on or near this unit, since these will corrode the
surface.
Specifications
Audio Section
FTC power output . . . . . . . . . . . . . . . . . . . . . . . . . 65 W + 65 W
(STEREO, 20 Hz to 20 kHz, 8 , 0.2 %)
Rated power output (Front, Center, Surround)
. . . . . . . . . . . . . . . . . . . . . 125 W per channel (1 kHz, 6 , 1 %)
Maximum power output (Front, Center, Surround)
. . . . . . . . . . . . . . . . . . . . 150 W per channel (1 kHz, 6 , 10 %)
Total Harmonic Distortion
. . . . . . . . . . . . . . . . . . . 0.06 % (20 Hz to 20 kHz, 8 , 50 W/ch)
Guaranteed speaker impedance . . . . . . . . . . . . . . .6 to 16
Input (Sensitivity/Impedance)
LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mV/47 k
Signal-to-Noise Ratio (IHF, short circuited, A network)
LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 98 dB
Video Section
Signal level
Composite . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Vp-p (75 )
Tuner Section
Frequency Range (FM) . . . . . . . . . . . . . . 87.5 MHz to 108 MHz
Antenna Input (FM) . . . . . . . . . . . . . . . . . . . .75 unbalanced
Frequency Range (AM)
9 kHz step . . . . . . . . . . . . . . . . . . . . . . . 531 kHz to 1602 kHz
10 kHz step . . . . . . . . . . . . . . . . . . . . . . 530 kHz to 1700 kHz
Antenna (AM) . . . . . . . . . . . . . . . . . . . . . . . . . . . .Loop antenna
Digital In/Out Section
HDMI terminal . . . . . . . . . . . . . . . . . . . . . . . . . .Type A (19-pin)
HDMI output type . . . . . . . . . . . . . . . . . . . . . . . . . . 5 V, 100 mA
HDMI input/MHL terminal. . . . . . . . . . . . . . . . . . . 5 V, 900 mA
USB terminal. . . . . . . .USB2.0 High Speed (Type A) 5 V, 2.1 A
iPod terminal. . . . . . . . . . . . . . . . USB, and Video (Composite)
ADAPTER PORT terminal . . . . . . . . . . . . . . . . . . . 5 V, 100 mA
Network Section
LAN terminal . . . . . . . . . . . . . . . . . . . . 10 BASE-T/100 BASE-TX
Favorite List Full This is displayed when you have
attempted to register a file in the
Favorites folder but the Favorites folder is
already full.
Status messages Descriptions
Manufactured under license from Dolby Laboratories. Dolby,
Pro Logic, and the double-D symbol are trademarks of Dolby
Laboratories.
Manufactured under license under U.S. Patent Nos: 5,956,674;
5,974,380; 6,226,616; 6,487,535; 7,212,872; 7,333,929;
7,392,195; 7,272,567 & other U.S. and worldwide patents
issued & pending. DTS-HD, the Symbol, & DTS-HD and the
Symbol together are registered trademarks of DTS, Inc. Product
includes software. © DTS, Inc. All Rights Reserved.