CommanderMT System installation guide XMRVRFM002
Table of Contents 2 Table of Contents Table of Contents ............................................................................................... 2 Congratulations .................................................................................................. 3 FCC Information .................................................................................................. 4 Cautions and Warnings ...................................................................................
Thank you for purchasing the Audiovox CommanderMT XM® Satellite Radio System. You are one step closer to experiencing the latest innovation in XM® Satellite Radio. XM® Satellite Radio will revolutionize your vehicle or in-home entertainment.
FCC Information 4 FCC Information NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in terference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
1. Do not install the CommanderMT Display Controller in a position that hinders your view through the windshield, or obstructs viewing of the dashboard indicators and displays. 2. Do not install the Display Controller where it may obstruct the operation or deployment of safety devices, such as airbags, etc. 3. Do not allow operation of the unit to detract from safe driving practices; remember that you are responsible as the vehicle operator to adhere to all safe driving and traffic regulations. 4.
CommanderMT Receiver Kit Components ^ menu 1 2 3 4 5 6 7 8 XM Mini-Tuner ^ CommanderMT Receiver Components 6 p/d 9 0 CommanderMT Display Controller Interconnect Cradle Remote Control FM Direct Adapter XM Car Antenna DIN Opening Trim Bezel Snap-On Mounting Plate 12 Vdc Power Cable
1. To prevent a short-circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. Connect power wires last. 2. Do not install the CommanderMT Display Controller in locations exposed to direct sunlight, or in areas subject to extreme temperatures, or damage could occur. 3. Incorrect installation may cause damage to the system. Mount the system components using the suggested methods recommended in this manual. 4.
Cabling Interconnections 8 Setting Up and Installing Y our Kit Your NOTE: The XM® signal can be received and processed virtually anywhere as long as there are no obvious satellite signal obstructions such as nearby buildings, high terrain, parking garages or tunnels. 1. Cabling Interconnections You can begin to enjoy XM® Satellite Radio as soon as the CommanderMT System Vehicle Kit installation is complete.
Interconnect Cradle with XM Mini-Tuner Power Cable with 2A In-line Fuse XM Antenna DIN Opening Trim Bezel To FM Antenna To FM Radio CommanderMT Display Controller FM Direct Adapter Cabling Interconnections Interconnect Diagram
Important/Antenna Installation 10 2 . Important! It is very important to make your power connection to a source that only supplies 12V when the vehicle key is in the accessory or ignition ON position. A connection to a 12V source that is always on, regardless of the key position, can lead to a battery drain if the CommanderMT System is left on when you leave your vehicle. ACCESSORY NO ACCESSORY POSITION POSITION Ignition Switch Accessory/On-Off Positions 3.
1. Do not install the antenna inside the vehicle passenger compartment. Mounting the antenna in the passenger compartment either on the from dashboard, or on the rear window deck area will cause reception issues and must be avoided. 2. Mounting the antenna on a non-metalic surface will also result in severe degradation in reception. • If an appropriate antenna mounting location cannot be identified, contact your local retailer installation department for additional guidance.
Antenna Installation 12 Antenna Mounting Methods • For antenna mounting locations at the rear of the roof, the antenna cable can be routed into the vehicle through the trunk. Always route the cable under the weather seal near the lowest part of the trunk to reduce possible water leaks. • Use pre-existing wiring channels created by the vehicle manufacturer whenever possible. Tools required • The antenna contains a powerful magnet that will secure it to a metal roof under normal driving conditions.
Be sure to locate your Display Controller below the top of the dash in your vehicle to keep the unit within easy reach while driving. Choosing a lower location in your installation should also make it easier to manage the cables and achieve a more desirable appearance when the installation is completed. See illustration below and be sure to locate your Display Controller within the outlined shaded areas. Display Controller Installation 4.
Display Controller Installation 14 The CommanderMT Display Controller can be installed using the DIN opening trim bezel or a snap-on mounting plate as shown below. The trim bezel permits in-dash or center console mounting, while the mounting plate can be used with optional custom brackets, such as swivel or vent mounts. a.
Using the Snap-On Mounting Plate To attach the CommanderMT cradle to optional mounting devices that are readily available at retail, attach the snap-on mounting plate to the rear of the CommanderMT Display Controller as shown below. Examples of Optional Aftermarket Mounting Alternatives Display Controller Installation b.
Connection Options 16 5. Connection Options The CommanderMT System provides an audio output signal in two ways: a. FM Direct Wiring - The FM direct adapter supplies a hardwired FM output, provided the FM Frequency option of the XM Mini-Tuner is turned on and tuned to an unused FM frequency.
ROTATE DIAL TO SELECT FM frequency Off Interconnect Cradle with XM Mini-Tuner To Vehicle Radio Low Level Audio Inputs Optional Audio Cable SAT-RCA Connection Options b. Low-Level Audio Output - For vehicle radio head units with auxiliary audio inputs, the audio signal can be routed through an optional audio cable (Part No. SAT-RCA) and applied to the auxiliary inputs of a radio or entertainment system. In this case, tolisten to the audio.
Cable Routing and Component Installation 18 6. Cable Routing and Component Installation Once you have established power connections, Display Controller and antenna placement, and audio connection, route all cables to the location where you will mount the Interconnect Cradle.
Installing the Cradle and Interconnecting Cables - Locate the Interconnect Cradle in a readily accessible location, such as the glove compartment, console compartment, or under the dashboard, so that the XM Mini-Tuner can be removed or replaced. Note also that the cradle must be situated close enough to comply with the CommanderMT Display Controller cable and Power Cable lengths (6’). b.
Warranty 20 12 MONTH LIMITED WARRANTY FM Satellite Radio XMRVRFM002 AUDIOVOX ELECTRONICS CORPORATION (the Company) warrants to the original retail purchaser of this product that should, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.
This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, MUST BE BROUGHT WITHIN 24 MONTHS FROM DATE OF ORIGINAL PURCHASE.
Audiovox Electronics Corporation 150 Marcus Blvd. Hauppauge, New York 11788 U.S.A. 1 800 645 4994 www.audiovox.com XM name and related logos are trademarks of XM Satellite Radio Inc. Printed on Recycled Paper ©2007 Audiovox Electronics Corporation. All rights reserved.
