Service manual

Installing the Audiovox CCS100 Cruise Control on the
Honda Pacific Coast PC800 Motorcycle
Page 4
Copyright © 2001-2006 by Bruce Pickett. Copying or printing for personal use is permitted. All other rights reserved. January 21, 2006
Alternative 2: For Servo Installation
In Left Front Upper Cowl
In addition to the panels removed for
Alternative 1, the following panels
must be removed (numbers in
parentheses refer to panel numbers in
the PC800 Service Manual):
• Mirrors (#1)
• Wind screen (#2)
o air duct grill
o garnish
o frame
o screen
o rubber seat
o air duct
• Meter Panel (#9)
• Meter Visor (#6)
Removal of the following additional
panels may make it easier to install the
cruise control system, although it is
possible to do the installation without
removing them:
• Fairing Protectors (#7)
• Front Lower Cowl (#8)
• Front Upper Cowl (#3)
Remove the air cleaner
housing assembly
• remove 2 self taping screws
holding the auto fuel valve to the
housing
• loosen the connecting tube band
clamp screws on each carburetor
intake
• loosen the spring clamp on the
breather tube at the rear of the
housing and remove the breather
tube
• lift the assembly out of the way