Service manual

Installing the Audiovox CCS100 Cruise Control on the
Honda Pacific Coast PC800 Motorcycle
Page 23
Copyright © 2001-2006 by Bruce Pickett. Copying or printing for personal use is permitted. All other rights reserved. January 21, 2006
On the side of the #1 (left) carburetor, remove the nut
that secures the throttle pulley to its shaft. Attach the
fabricated bellcrank to the shaft, then use a small
amount of Locktite or blue RTV on the threads of the
shaft, and secure the nut back in place. (
Caution - do
not get any thread locking compound on any of the
bike's plastic, as this may cause damage).
Anchor, forward-pulling actuator cable, and downward bellcrank