Installation Instructions Model CCDF Color Camera External Mount CCDF FEATURES: l High Resolution, 1/3”CCD Color Camera l Compact Zinc Alloy Die Cast Body l Waterproof Housing l Waterproof Microphone l Adjustable Mounting Angle l Wide Angle Lens l Flush Mount or Surface Mount 128-6951 1 of 12
Color Camera View: Cable Connector End View: 1 128-6951 2 of 12
Specifications: 1. Signal System: NTSC 2. Voltage: DC12V 3. Current: 80mA 4. Image Sensor: 1/3” CCD Color Sensor NTSC: 510 X 492 picture elements 5. Horizontal Definition: 420 Lines 6. Viewing Angle: 120 degrees 7. Minimum Illumination: 0.8 LUX 8. Outer Dimensions: 1.18”(W) x 1.10”(H) x 1.65”(D) 9. Weight: 2.
Contents: 3 128-6951 4 of 12
Contents Description: 1. Camera: 1 2. Support Bracket: 1 3. Lock Nut: 1 4. Protective Cover: 1 5. Top Cover: 1 6. Flat Washer 1: 1 7. Flat Washer 2: 1 8. Slant Washer 1: 1 9. Slant Washer 2: 1 10. Tapping Screw: 2 11. Combine Screw: 2 12. Washer: 2 13.
Flush Mount Note: 1. Camera 6. Flat Washer 1 3. Lock Nut 14. Mounting Plate 5.
Flush Mount Installation: 1. Select a suitable mounting location in the rear center of vehicle. Check behind panel for wire routing access and confirm that the drill will not damage any existing components. Use a 7/8” hole saw to drill the mount ing hole. 2. Screw the lock nut with the threaded side toward the camera body in the showed direction, then put the camera neck through the mounting hole with the lens exposed and wire cable facing down. 3.
Angle Flush Mount Size of Mounting Holes (See the Attached Page) Note: 1. Camera 3. Lock Nut 5. Top Cover 7. Flat Washer 2 8. Slant Washer 1 9.
Angle Flush Mount Installation: 1. Select a suitable mounting location in the rear center of vehicle. Check behind panel for wire routing access and confirm that the drill will not damage any existing components. Drill four 1/8” positioning holes and one 7/8” mounting hole at the mounting location according to the drawing of Size of Mounting Holes. 2. Screw the lock nut (# 3) and the flat washer 2 (# 7) with the non-threaded side to the camera neck in the showed direction. 3.
Surface Mount Note: 1. Camera 4. Protective Cover 11. Combine Screw 2. Support Bracket 5. Top Cover 12. Washer 3. Lock Nut 6. Flat Washer 1 13.
Surface Mount Installation: 1. Locate suitable mounting location in the rear center of the vehicle and use the support bracket (# 2) as a template to mark and drill two 5/32” holes on the mounting location. 2. Put the support bracket (# 2) onto the camera neck, then screw the lock nut along the camera neck to secure the bracket (# 2) to the camera body (# 1) in the showed direction. 3.
© 2004 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y.
