Installation guide

Valet Mode
When valet mode is activated the status LED will light solid, and all security
functions will be disabled.
To enter or exit valet mode simply follow the 4 steps
outlined below:
1. Turn the vehicle's ignition ON.
2. Push and hold the
programminglvalet button.
3.
The LED will turn on solid when valet mode is active
4. Release the
programminglvalet button.
Eliminating Arm / Disarm Notification Chirps
System ARM/DISARM chirps can be toggled ON or OFF without entering the
programming feature banks.
1. Turn the ignition ON then OFF.
2.
Press and release the valet/programming button 3 times. The system
will respond with 1 chirp for ON or 2 chirps for OFF.
Manually Overriding the Security System
Your system can be disarmed without the use of the transmitter. This is
necessary, since
you will need the ability to operate your vehicle if the transmitter
is lost
or its battery fails. To by-pass the alarm system;
1.
Open the vehicle door. The alarm will sound.
2.
Turn the ignition key to the ON position.
3. Within
10 seconds, press and release the valet push button switch.
The alarm system will stop sounding and enter the (by-passed) mode. You can
now start and operate the vehicle normally.
2010 Audiovox Electronics Corporation. All rights reserved.
5