Owner`s manual

BT1611i
9
allowing the radio to stop at a broader range of
signals. To set the unit to select only strong
local stations during automatic tuning, turn the
AUDIO CONTROL to choose “Local”.
VOL PGM (00-46)
Use the “VOL PGM” option to select the default
volume the radio will assume when first turned
on. To program a specific start-up volume level,
turn the AUDIO CONTROL to select the
desired level.
BEEP TONE
The beep tone feature allows the selection of
an audible beep tone to be heard each time a
button is pressed on the face of the radio.
“BEEP TONE On” is the default display. Turn
the AUDIO CONTROL to select the “BEEP
TONE Off” option.
iX-BASS
Press the BASS button (15) to activate the iX-
BASS feature. When listening to music at low
volume levels, this feature will boost the bass
and treble ranges to compensate for the
characteristics of human hearing. Press BASS
again to deactivate this feature.
Subwoofer
Press the SUB button (18) to activate the
Subwoofer function. Press again to turn the
Subwoofer function off.
NOTE: The Subwoofer feature only works
when an external amplifier and subwoofer
are connected via the Sub line out
connection on the back of the unit.
Liquid Crystal Display (LCD)
The liquid crystal display (LCD) panel (8)
displays the frequency, time and activated
functions of the unit.
NOTE: After being subjected to cold
temperatures, LCD panels may take longer
to respond and visibility of the numbers on
the LCD may decrease slightly. The LCD
display will return to normal when the
temperature increases to a normal range.
Auxiliary Input
Use the Aux In cables on the back of the unit to
connect a portable media device for playback
through the vehicle sound system. To access
the Auxiliary Input mode, press the MODE
button (2) until "AUX" is indicated in the display.
Front Panel Release
The front panel release button (10) releases the
mechanism that holds the front panel to the
chassis.
Detaching the Front Panel
To detach the front panel, first press the front
panel release button (10) to release the left side
of the panel. Next, grasp the released side and
pull it off the chassis. After removing the front
panel, store it in the supplied carrying case to
protect it from dirt and damage.
Re-attaching the Front Panel
To re-attach the front panel, make sure the
electrical terminals on the back of the panel are
free of dust and dirt, as debris could cause
intermittent operation or other malfunctions.
Position the right side of the panel in place so
that it is correctly engaged, then lightly press
the left side of the panel until the mechanism
locks it into place.
1
2
/
TUNE
BASS
SUB
RECORD
BT1611 MP3/WMA RECEIVER
MENU
REMOVE FRONT PANEL