Owner`s manual

BT1611i
29
TROUBLESHOOTING
CD Player Error Codes
If a problem should develop while operating the
CD player, an error code (ER-1, ER-2, etc.)
may appear on the display panel. This can
indicate a number of problems with the unit,
including a mechanical error or an error in the
microprocessor control of the player. If an error
code should appear, try ejecting and reloading
the disc into the player. While the disc is out of
the unit, make sure it is clean and undamaged,
and then load it correctly. If this does not solve
the problem, pressing the RESET button (11)
may help, but will erase the time and preset
memory (see “Reset Button” on page 10). If the
suggested measures do not solve the problem,
contact an approved warranty station near you
for further assistance.
Potential Errors
Problem Cause
Corrective
Action
Does not
operate
(display
does not
light)
No power to
yellow wire; no
power to red
wire
Check connec-
tion and/or vehi-
cle fuse with
test light.
Inline fuse
blown
Replace fuse.
No power
to unit
Inline fuse
blown
Check/replace
fuse.
Not all
speakers
operate
Incorrect
splices or con-
nections
Check splices
and connec-
tions.
Speaker wires
shorting to
chassis ground
or to each other
Check splices
and insulate all
bare wires.
Blows
fuses
Power wire
shorting to
ground
Make sure wire
is not pinched.
Speaker wires
shorting to
ground
Make sure wire
is not pinched.
Incorrect fuse
or fuse too
small
Install fuse of
correct rating.
CD skips
too much
Receiver mount
is not solid or
backstrap is not
secure
Check mounting
and backstrap
and tighten if
needed.