Operating instructions

BT1611i
I
®
§
@rn
iPod Nano
\,..._ _ __ J
fl ~]
,((),
iPod Mini
iPod
r ~-l'
I I
1 -' t
.'" "( /'
t
j '\)
I \ .'
" -'
iPod Gen5
~
CD
@~
®
@
CJ
0
Gray/Black (-)
Gray(+) @CD
@
VI,'~IBI .. k (-~ ) ®
Violel(+) ~
~ ~ ~ ~
~
~
Wlile/Black (-)
®@ Wlile(+)
VVIRING
1. Power Antenna (dark blue wire) - Connect
to the power antenna or
an amplifier. If not
used, tape the bare end of wire.
2. Ground (black wire) - Connect to the
ground terminal or a clean, unpainted part
of the chassis.
3. Memory/Battery (yellow wire) - Connect to
the battery or to a 12 volt power source
that is always live. The radio will not work
if this wire is not connected.
4. Accessory/Ignition (red wire) - Connect to
the existing radio wire or radio fuse.
5. Left Front Speaker
6. Right Front Speaker
7. Left Rear Speaker
8. Right Rear Speaker
9. RCA Outputs to Amplifier
10. Auxiliary Input RCAs (yellow)
11. Antenna
12. Subwoofer Output (blue)
13. iPod/jLink connector -
Use this 8-pin DIN
socket to connect your jLink iPod cable.
14. jLinkcable (iPod Cable)
NOTE:
The amplifiers in this radio are only
designed for use with four speakers. Never
combine (bridge) outputs for use with two
speakers. Never ground negative speaker
leads
to chassis ground. Failure to wire
exactly as shown may cause electrical
damage to the radio.
6