Operating instructions
9.
Attach one end
of
the perforated support
strap (supplied) to the screw stud
on
the
rear
of
the chassis using the hex nut
provided. Fasten the other end
of
the
perforated strap to a secure part of the
dashboard, either above or below the
radio, using the screw and hex nut
provided. Bend the strap, as necessary, to
position
it.
CAUTION: The rear ofthe radio
must
be
supported with the strap to
prevent damage to the dashboard from
the weight
of
the radio or improper
operation due to vibration.
10. Re-attach the front panel to the chassis
and test radio operation
by
referring to the
operating instructions for the unit.
NOTE:
For
proper
operation
of
the CD
player. the
chassis
must
be
mounted
within
20°
of
horizontal.
Make
sure
the
unit
is
mounted
within
this
limitation.
Kit
Installation
Ifyour vehicle requires the use
of
an
installation
kit to mount this radio, follow the instructions
included with the installation kit to attach the
radio to the mounting plate supplied with the kit.
1.
Wire and test the radio as outlined
in
the
Universal Installation instructions.
2.
Install the radio/mounting plate assembly
to the sub-dashboard according to the
instructions
in
the installation kit.
3.
Attach the support strap to the radio and
dashboard as described
in
the Universal
Installation instructions.
4.
Replace the dashboard trim panel.
ISO
Installation
This unit has threaded holes
in
the chassis side
panels which may
be
used with the original
factory mounting brackets of some vehicles to
mount the radio to the dashboard. Please
consult with your local car stereo shop for
assistance
on
this type
of
installation.
1.
Remove the existing factory radio from the
dashboard or center console mounting.
Save all hardware and brackets as they
will
be
used to mount the new radio.
2.
Carefully unsnap the plastic frame from
the front
of
the new radio chassis. Remove
and discard the frame.
3.
Remove the factory mounting brackets
and hardware from the existing radio and
4
BT1611i
attach them to the new radio.
Do
not
exceed M5 x 9
MM
maximum screw size.
Longer screws may damage components
inside the chassis.
4.
Wire the new radio to the vehicle as
outlined
in
the Universal Installation
instructions.
5.
Mount the new radio assembly to the
dashboard or center console using the
reverse procedure
of
step 1.
Reconnecting
the
Battery
When wiring is complete, reconnect the battery
negative terminal.