Operating instructions

BT1611i
TROUBLESHOOTING
CD Player Error Codes
If a problem should develop while operating the
CD player, an error code (ER-1, ER-2, etc.)
may appear on the display panel. This can
indicate a number
of problems with the unit,
including a mechanical error or an error in the
microprocessor control
of the player. If an error
code should appear, try ejecting and reloading
the disc into the player. While the disc is out
of
the unit, make sure it is clean and undamaged,
and then load it correctly.
If this does not solve
the problem, pressing the
RESET button (11)
may help, but will erase the time and preset
memory (see "Reset Button"
on page 10). If the
suggested measures do not solve the problem,
contact
an approved warranty station near you
for further assistance.
Potential Errors
Problem
Cause
Corrective
Action
Does not No power to Check connec-
operate yellow wire; no tion and/or vehi-
(display power
to red cle fuse with
does not wire
test light.
light)
Inline fuse
Replace fuse.
blown
No power Inline fuse Check/replace
to unit blown fuse.
Not all
Incorrect
Check splices
speakers splices or con- and connec-
operate nections tions.
Speaker wires
Check splices
shorting to and insulate all
chassis ground bare wires.
or
to each other
Blows Power wire Make sure wire
fuses shorting
to is not pinched.
ground
Speaker wires Make sure wire
shorting
to is not pinched.
ground
Incorrect fuse Install fuse
of
or fuse too correct rating.
small
CD skips Receiver mount Check mounting
too much is not solid or
and backstrap
backstrap is not
and tighten
if
secure needed.
29