Operating instructions

Para obtener instrucciones en Espanol, dirijase a la pagina 32.
PREPARATION
BT1611i
Getting Started
Congratulations on your purchase of the Phase
Linear 8T1611 i Mobile AM/FM/CD/MP3IWMA
Receiver. It's a good idea to read all
of the
instructions before beginning the installation.
We recommend having your Phase Linear
BT1611 i installed by a reputable installation
shop.
Contents
Installation Instructions 3
Wiring 6
Operating Instructions 7
Tuner Operation
11
CD Player Operation 13
MP3IWMA Operation
15
Using a USB Device or SO Card 19
iPod Operation
21
Bluetooth Operation 23
Remote Control 27
Care and Maintenance 28
Troubleshooting 29
Specifications 30
Installation Requirements
This unit is designed for installation in cars,
trucks and vans with an existing radio opening.
In many cases, a special installation kit will be
required to mount the radio to the dashboard.
These kits are available at electronics supply
stores and car stereo specialty shops. Always
check the kit application before purchasing
to
make sure the kit works with your vehicle. If you
need a kit but cannot locate one, call our
customer support line at 1-800-323-4815.
(U.S.A. and Canada only.)
Tools and Supplies
The following tools and supplies are needed to
install the radio.
•
Torx type, flathead and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove eXisting radio (screwdriver,
socket wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16-18 gauge speaker wire
Speaker Requirements
Only connect speakers rated with a load
impedance
of 4 ohms. Speakers with a load
2
impedance of less than 4 ohms could damage
the unit.
Disconnect Battery
Before you begin, disconnect the battery
negative terminal.
--------
Toll-Free Installation Assistance
If you require assistance, contact Technical
Support at 1-800-323-4815 from 9:00 a.m.
to
6:00 p.m. EST Monday through Friday (U.S.A.
and Canada only.)