LCM0681TV Owner’s Manual Revision C 3/2001
Important Notice It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that is located in the motor vehicle at any point forward of the back of the driver’s seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. In the interest of safety, the LCM0681TV should never be installed where it will be visible, directly or indirectly, by the operator of the motor vehicle.
FEATURES • • • • • • • • • • • 6.
FRONT PANEL FEATURE Figure 1 2 5 3 4 1 7 9 6 8 10 Revision C 3/2001 11
FRONT PANEL FEATURES – See Figure 1 1. Power Button- (Bright red when system is ON, dim when system is OFF) 2. Channel Up/Down- Changes the TV channel 3. Volume Up/Down- Controls volume to headphone jacks and external speakers if connected. 4. Auto Pro Switch- Auto Program used to program local channels into TV memory. Press when vehicle is in a new location. 5. Source Select- Used to select one of the three A/V sources. The fourth source is plugged into the RCA jacks on the rear of the unit.
REMOTE CONTROL OPERATION 1 6 3 2 BATTERY INSTALLATION Before attempting to operate your Remote Control, install the batteries as described below. 1) Turn the remote control face down. Press down on the ridged area of the battery cover, and slide it off. 2) Install two “AAA” batteries as shown. Make sure that proper polarity (+ or -) is observed. 3) Slide the cover back until it clicks into position. The remote control will operate the LCM0681TV, Flexvision Televisions and Video Cassette Players.
Remote Controlled TV Functions 1. POWER ON/OFF Press this button to turn the LCM0681TV on. The channel number or current video source will be displayed on screen, and the picture will appear in a few seconds. Press the button again to turn the LCM0681TV off. 2. DIRECT ACCESS (0-9) BUTTONS Use these buttons to make a direct channel selection. The channel number chosen will be displayed on the screen for about 4 seconds. The direct access is carried out with 0-9 keys (0-99CH).
6. MUTE BUTTON Press this button to shut off the sound at the headphone stations. The screen will display the volume adjustment bar for 6 seconds, indicating that the sound has been turned off. Pressing the button again restores sound to the previously set level. The mute feature may also be released by pressing the VOLUME UP/DOWN buttons. 7. TV / VIDEO BUTTON Any video equipment connected to the AUDIO/VIDEO inputs can be used with the TV by pressing this button.
11. POWER BUTTON This button is used to turn the VCP on and off. 12. “REW” REWIND BUTTON If this button is pushed while the tape is stopped, the tape will rewind. If this button is pushed while the tape is playing, the VCP will go into rewind search mode. For more information consult the Audiovox VCP owner’s manual. 13. PLAY BUTTON Press this button to activate play mode while a tape is loaded into the VCP. This button may also be used to disengage search and pause modes.
(B) To tune to weak or marginal channels with the CHANNEL UP/DOWN buttons, press the SKIP/SEARCH button on the Remote Control Unit until “SKIP MODE OFF” is displayed on the bottom of the screen. Tune to the desired channel using the CHANNEL UP/DOWN buttons or go directly to the channel by using the 0-9 buttons on the Remote Control. 3. To ERASE a channel, press the ERASE/WRITE button on the Remote Control Unit until “MANUAL MEMORY XX ERASE” is displayed on screen.
OPERATION Overhead Dome Lights The lights integrated into the LCM0681TV are controlled by a three position slide switch. Sliding the switch to the on position will turn the lights on. The off position will prevent the lights from turning on at all times, and the auto position will allow the lights to turn on and off with the vehicle’s interior lighting. Do not leave the vehicle unattended with the dome light switch in the on position, as this could result in a discharged battery.
Remote Sensor The LCM0681TV incorporates an infrared sensor, which relays the signals from the remote control to allow the LCM0681TV and VCP to be controlled simply by pointing it’s remote control at the remote sensor. This provides control of auxiliary equipment such as an Audiovox Video Cassette Player. The infrared sensor can relay signals from any manufacturer’s remote control to it’s respective component connected to the Video 1 and 2 inputs, such as a DVD player.
LCM0681TV Jack Panel Revision C 3/2001
Whenever the RF modulator is on, broadcast radio reception will be poor. Turning the remote mounted toggle switch off will allow for normal radio reception. Video Output The LCM0681TV provides a video output for an optional video monitor(s). This output will provide a video signal that duplicates the signal displayed by the LCM0681TV to an additional monitor or video display. Please see your installer for more information.
TYPICAL SYSTEM CONNECTIONS Antenna V1 VCP To RF Transmitter Headphone Yellow (Video In) White (Audio In Left) To RF Transmitter PIN 1- Power / Red PIN 2- Power GND / Black Red (Audio In Right) Headphone V2 DVD Accessory Harness White (Audio Out L) Red (Audio Out R) Yellow (Video Out) Revision C 3/2001 2-PIN IR Connector 4-PIN Power Connector Negative Switching / GM Type Gray- Entry Switch / Negative Black / Constant +12VDC / Dome Circuit Red- Chassis Ground PIN 3- Gray / Auto OR PIN 4- Black / Co
Televisions AVT-988 9” Color Television with Remote (12V) AVT-1498 13” Color Television with Remote (12V) VCP and DVD Players for use with TV’s and LCD AVP-7000 Video Cassette Player (12V) AVP-7285 Video Cassette Player (12V) Single Disc DVD Player Headphones Wireless Headphones Headphones with Pivoting Earcup Headphones with volume Control on Cord Studio Quality Headphones Miscellaneous Remote Controls Wallmount Family Radio Service with 4 Handsets Replacement Handset 12V Corded Vacuum Rechargeable Flashli
AM/FM Stereo w/Cassette Player (analog tune) Weatherproof Housing 50 Watt 6 ½” Speakers (white/black) 30 Watt 5” Speakers (white/black) 30 Watt 4” Speakers Marine Radio Antenna Revision C 3/2001 MS220 MRH211 AMS6 AMS5 AMS4 AN125
Troubleshooting PROBLEM Poor TV Reception SOLUTION • • • Poor radio reception (FM modulator installed) • • • IR sensor inoperative • • • Revision C 3/2001 Perform auto programming of the tuner Verify antenna condition. NOTE: Due to the nature of TV signals, vehicle motion, direction the vehicle is facing, distance from the transmitter, nearby surroundings and weather may adversely affect TV reception.
-16- UDIOVOX PECIALIZED PPLICATIONS, L.L.C. 23319 Cooper Dr. Elkhart, IN 46514 800-688-3135 www.asaelectronics.
Revision C 3/2001
