Owner's Manual
Table Of Contents
- Owner's Manual
- Table of Contents
- System Features
- Accessories
- Monitor Features (SB10MD1)
- Monitor Features (SB10M1)
- Getting Started
- Home Main Menu
- System Applications
- SmartStream Android
- SmartStream iOS
- HDMI Port Information
- USB & SD Card Playback
- Wi-Fi Dual Screen
- Dual Screen
- Wi-Fi Setup
- VOXX LINK
- WFMM
- IR Headphone Transmitter
- Language
- About Device - Check for Update
- Device Name & Accounts
- Time Zone & Reset
- Volume & Brightness Control
- DVD Playback (SB10MD1)
- Media Type and File Type Compatibility
- Troubleshooting
- General Specifications
- Compliance Information
- Quick Start Guide
- Universal Installation
- Product Info
- Product Registration
UNIVERSAL INSTALLATION 10”.1 SEATBACK ENTERTAINMENT SYSTEM (Seat Back Mount)
© 2018 Voxx Automotive, Inc. All rights reserved.
Page 8 of 8
730148A1
6. Re-install headrest. NOTE: Some slight
modification may be done to the bracket
cover to allow headrest to move up and down
freely. (Figure E6)
7. Continue routing harnesses following factory
harnesses from the lower seat to a central
location in the vehicle. Attach to T-Junction
harness.
F. Power/Ground Location
1. Locate an Accessory Power source (+12 VDC
should be present when the ignition key is in the
accessory and run positions. 0 VDC should be
present when ignition key is in the off position).
Locate a good ground. Generally, these wires
can be located at ignition switch, power outlet, or
fuse box. NOTE: Ensure that the switched
power is fused at the source. Failure to do so
may result in vehicle and wiring damage.
G. Reassemble Trim
1. Trim all wire tie ends
2. Reassemble all trim removed in earlier sections.
H. Complete Installation
1. Install (2) AAA batteries in each headphone set.
2. Store remotes, owner’s manual and
headphones in center console, glove box, or
seat back pockets.
Figure
E6