Owner's Manual
Table Of Contents
- Owner's Manual
- Table of Contents
- System Features
- Accessories
- Monitor Features (SB10MD1)
- Monitor Features (SB10M1)
- Getting Started
- Home Main Menu
- System Applications
- SmartStream Android
- SmartStream iOS
- HDMI Port Information
- USB & SD Card Playback
- Wi-Fi Dual Screen
- Dual Screen
- Wi-Fi Setup
- VOXX LINK
- WFMM
- IR Headphone Transmitter
- Language
- About Device - Check for Update
- Device Name & Accounts
- Time Zone & Reset
- Volume & Brightness Control
- DVD Playback (SB10MD1)
- Media Type and File Type Compatibility
- Troubleshooting
- General Specifications
- Compliance Information
- Quick Start Guide
- Universal Installation
- Product Info
- Product Registration
UNIVERSAL INSTALLATION 10”.1 SEATBACK ENTERTAINMENT SYSTEM (Seat Back Mount)
© 2018 Voxx Automotive, Inc. All rights reserved.
Page 1 of 8
730148A1
Document #730148 Created ACH 12/20/2018
Revised ACH 12/20/18 – A1
Kit Contents:
Item #
Qty.
Component Description
1
2
SB10MD1, SB10M1 Monitors
2
2
L Connector Cable
3
1
T-Junction Cable
4
2
IR Headphone
5
2
Metal Shaft Bracket, Black
6
2
Metal Stent Briquetting, Black
7
2
Plastic Stent, Black
8
2
Bracket Cover, Black
9
2
Screw Cap
10
2
Nylon Tie
11
1
Screw Pack
12
1
SB10UHD Owner’s Manual
13
1
Installation Manual
14
1
Voxx Registration Card
15
1
SB10UHD Owner’s Manual
Hardware Bag Contents:
Item #
Qty.
Component Description
1
1
Screw Pack
1
20
Flat Washer
10
Flat Nut
10
Lock Washer
12
Screws, Black
4
Screws, Silver
Additional Items Required for Installation:
Item #
Qty.
Component Description
Recommended Tools:
Safety Tools
Seat/ Floor Covers
Blankets
Installation Tools
10mm Socket/Ratchet
#2 Phillips Screwdriver
NRT-Nylon Removal Tool
Special Tools
Color Applicability/ Trim Level:
Vehicle Trim Color
Accessory
Color
X
X
X
X
General Applicability:
Universal
Issues
Vehicles with NO guide sleeves
LEGEND:
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CRITICAL PROCESS: Proceed with caution to
ensure a quality installation. These points will be
audited on a completed vehicle installation.
TOOLS & EQUIPMENT: This calls out the specific
tools and equipment required for this process.
REVISION MARK: This mark highlights a change
in installation with respect to previous issue.
INSTRUCTION/ INSTALLATION NOTES:
• After Safety mandated preparatory steps have been
taken, the installation sequence is the suggested method
for completing the accessory installation.
• When prying panels, use masking tape on all surfaces
that a tool may come in contact with to prevent marring.
• After a wire tie is fully fastened, cleanly cut excess wire
tie length with a pair of wire cutters.
• The wiring information is on an “as is” basis without any
representation or warranty. It is the installer’s
responsibility to verify any circuit before interfacing with it
using a digital multi-meter.
• Manufacturer’s service documents can be used for any
vehicle disassembly that may be depicted differently from
what the instruction states.
• Use Wiring Diagram on last page of document to clarify
cable or component names.