Owner`s manual

- 4 -
Warnings and Cautions
SEE MARKING ON BOTTOM OF PRODUCT
Caution
This product uses a laser. Use of controls or
adjustments or performance of procedures
other than those specied may result in
hazardous radiation exposure. Do not open
covers and do not repair the unit yourself.
Refer servicing to qualied personnel.
Visible laser radiation when open. Avoid
exposure to beam.
Class 1 Laser Product
This unit must be opened only by qualied
technicians to prevent accidents caused by
the laser beam.
THE LIGHTNING FLASH AND ARROWHEAD
WITHIN THE TRIANGLE IS A WARNING SIGN
ALERTING YOU OF “DANGEROUS VOLTAGE”
INSIDE THE PRODUCT.
THE EXCLAMATION POINT WITHIN THE
TRIANGLE IS A WARNING SIGN ALERTING
YOU OF IMPORTANT INSTRUCTIONS
ACCOMPANYING THE PRODUCT.
Please respect the environment and
prevailing regulations.
Before you dispose of batteries, ask your
dealer whether they are subject to special
recycling and if they will accept them for
disposal.
WARNING: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK HAZARD, DO NOT
EXPOSE THIS PRODUCT TO RAIN OR
MOISTURE. THE APPARATUS SHALL NOT BE
EXPOSED TO DRIPPING OR SPLASHING.
FCC Information
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a mobile installation.
This equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If reception, which can be
determined by turning the equipment o
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving
antenna
• Increase the separation between the
equipment and the receiver
This product
contains a low
power laser
device.
The marking plate is located on the bottom
enclosure of the apparatus.
CLASS 1
LASER PRODUCT
X