Owner's Manual
Table Of Contents
Antenna: Cord length 9 feet
Installation:
Place antenna 3 inches
(minimum) from anyobstructions
Orientation: Vertical; antenna
facing downwards (as seen in
diagram)
(+) 12V BATTERY
(1)
GROUND
(1)
3
CM-6XXX
CM-7XXX
X
DBALL2
DB
DBAL
D
DBAL
DB
A
A
DBAL
DBA
A
A
A
D
A
A
A
A
AL
D
A
A
A
A
DBA
A
D
D
A
L2
L2
L2
L2
2
2
2
2
2
2
2
2
2
4X10
5X10
DS4
DS4+
FLCAN
2
2
2
+
HRN-CRF-02
WIRING GUIDE
Digital CarLink system
D O C DATE: 11.14.17
Federal Communications Commission (FCC) Compliance Statement. This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that m ay cause undesired
operation. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonabl e protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more if the following measures: • Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver • Connect the equipment into an outlet on a circuit ifferent from that to which the receiver is connected • Consult the dealer or an experienced radio/TV technician for help
This system must be installed by a professional.
(1) Connect when using with Flashlogic, EVO-ALL, Code, Pursuit or Prestige