Owner's Manual

58
PARTS REQUIRED FOR INSTALLATION OF : OMEGA AL-XX70-B
Telematics device HRN-MCAR-01 AL-XX70-B BLADE-AL (64)
STEP 1. CONFIGURE THE REMOTE STARTER
The ADS Weblink (ADS-USB) is required to properly configure the Omega AL-XX70-B remote starter to ac-
cept the telematics device. When flashing the Omega AL-XX70-B remote starter, please ensure the remote
starter firmware and BLADE-AL (64) firmwares are updated to the latest firmware available. Also ensure
to set the “Data Port Protocol” to : “Green = iData”.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
HRN-DRS-02 &
HRN-LLRS-01
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
HRN-DRS-01
HRN-LLRS-01
BLACK
DATA PORT
OR
OL-ADAPTER-B2G
GREEN DATA PORT
METHOD #1
METHOD #2
METHOD #3
INSTALLATION, WIRING & PROGRAMMING GUIDE