Owner's Manual

50
PARTS REQUIRED FOR INSTALLATION OF : PURSUIT (E) Models
Telematics device HRN-MCAR-01 (E) Model (Exc.PRO9233E) HRN-DRS-02
STEP 1. CONFIGURE THE REMOTE STARTER
The Voxx VEPROG is required to upgrade the latest Firmware and properly configure the Pursuit (E) remote
starter to accept the telematics device. When updating the Pursuit (E) remote starter, please ensure to
choose the correct Protocol option from Programming Bank 2, Feature #18, Option 3 or 4 “ADS TEL”.
STEP 2. CONNECT
STEP 3. NETWORK CONNECTIVITY
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
OR
3
HRN-DRS-02
(1) Connect to supply power to telematics device
INSTALLATION, WIRING & PROGRAMMING GUIDE