Owner's Manual

48
PARTS REQUIRED FOR INSTALLATION OF : PRESTIGE (Z) Models
Telematics device HRN-MCAR-01 (Z) Model
STEP 1. CONFIGURE THE REMOTE STARTER
The ADS Weblink (ADS-USB) is required to properly configure the Prestige (Z) remote starter to accept
the telematic device. When flashing the Prestige (Z) remote starter, please ensure to choose the correct
Protocol option from Programming Bank 2, Data Port Protocol, “ADS”.
STEP 2. CONNECT
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
(1) Connect only when remote starter is not supplying power to telematics device
INSTALLATION, WIRING & PROGRAMMING GUIDE