Owner's Manual

40
PARTS REQUIRED FOR INSTALLATION OF : DIRECTED DS4 - DS4+
Telematics device HRN-MCAR-01 DS4 / DS4+ HRN-DRS-01 or
HRN-DRS-02
STEP 1. CONFIGURE THE REMOTE STARTER
The Directed XKloader 2 or 3 is required to properly configure the DS4 / DS4+ remote starter to accept the
telematic device. When flashing the DS4 / DS4+ remote starter, please ensure to choose the “Smartstart”
telematic protocol.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
HRN-DRS-02
INSTALLATION, WIRING & PROGRAMMING GUIDE